Level-5 finishes, sheetrock installation, skim coating, and water-damage drywall repair for homes and businesses across Brooklyn. Same-week estimates. Fully licensed and insured.
Same-week estimates across Brooklyn — residential & commercial.
Brooklyn Elite Drywall has spent 20+ years hanging, finishing, and repairing walls and ceilings across this borough, from the pre-war brownstones of Park Slope to the attached row houses of Bath Beach and Bensonhurst, where the plaster is often original and the walls are rarely square. With drywall, anyone can get a wall mostly flat. The difference between mostly flat and truly flat is the final coat, and the final coat is what we obsess over. Our crews hang 1/2-inch and 5/8-inch Type X fire-rated board, moisture-resistant green board, and mold-resistant panels, then tape, mud, and sand to a clean Level-4 finish, or a glass-smooth Level-5 when the light in a room calls for it.
We handle the jobs most Brooklyn homeowners struggle to find a real specialist for: popcorn ceiling removal, skim coating over tired pre-war plaster, nail-pop and crack repair, corner-bead replacement, and soundproofing between attached units. The most underrated fix in this borough is a full skim coat. People assume a wavy, patched-up wall has to be torn out, when a skim coat over sound plaster gets you a flat, paint-ready surface for a fraction of the cost, and a hundred-year-old room looks new again once the light stops catching every old ripple. Because drywall is the only thing we do, we finish faster and cleaner than a general contractor juggling ten trades, and we stand behind every seam we close.
Residential, commercial, and specialty finishing — drywall is all we do.
New-wall and ceiling drywall installation using 1/2-inch and 5/8-inch panels, screwed to wood or metal studs at 12–16 inches on center, with joints staggered and fastened to code.
Patching holes, cracks, nail pops, and water-damaged sections: cut out, backed, taped with mesh or paper tape, and blended into the surrounding wall so the repair disappears under paint.
Full skim coats over rough, textured, or damaged plaster to create a flat, paint-ready surface, the fix for pre-war Brooklyn walls that have taken decades of wear.
Three-coat taping with joint compound, feathered and sanded to a Level-4 finish for most rooms or a Level-5 finish for walls under raking light and high-gloss paint.
Scraping and skimming outdated popcorn (acoustic) ceilings to a smooth finish, with dust containment and, where required, testing before removal.
Removing saturated gypsum board and insulation after leaks, drying the cavity, and rebuilding with moisture-resistant board to stop mold before it starts.
Hanging and finishing ceiling board, including 5/8-inch sag-resistant panels for wider joist spacing and clean, crack-free ceiling lines.
Acoustic assemblies using resilient channel, mineral wool, and damping compound to cut noise between units, a common need in Brooklyn's attached and multi-family homes.
Framing new partitions and closets with metal studs or wood, ready for board, so we can take a project from open space to finished room in one crew.
Partition framing, drywall, and Level-4 finishing for offices and storefronts, coordinated to your buildout schedule.
Moisture- and mold-resistant board and fire-rated assemblies for commercial kitchens and back-of-house areas.
Type X and Type C fire-rated drywall systems installed to the assembly's listed rating for corridors, demising walls, and shafts.
A full skim coat over the entire surface, the finish that eliminates flashing and joint shadowing under LED and natural light.
Green board and paperless mold-resistant panels for bathrooms, basements, and below-grade Brooklyn spaces.
STC-rated assemblies with resilient channel, mass-loaded barriers, and damping compound between the layers of board.
We measure, assess the substrate, and give you a clear written quote, usually within the same week.
We mask floors and fixtures and set up dust containment before any cutting begins.
Board goes up to code, then a three-coat finish sanded to your chosen level.
We walk every seam with you under a work light; if we can spot it, we fix it before we call it done. The finish isn't finished until it disappears under paint. Then we haul away all the debris.
They skim-coated our whole living room after we pulled down old wallpaper and the walls look brand new. Smooth, no seams showing, and they cleaned up better than they found it.
Had water damage in a bedroom ceiling. They cut it out, dried it, and put up moisture-resistant board same week. Fair price and you can't tell anything ever happened.
Removed the popcorn ceilings in two rooms and finished them Level 5. Under the new lights they're perfectly smooth. Professional crew, showed up on time both days.
We needed a new partition wall and closet framed and boarded. One crew did framing through finish in two days. Exactly what I wanted: no juggling three contractors.
Brooklyn Elite Drywall proudly serves homeowners and businesses throughout Brooklyn, NY and the surrounding areas, including Bath Beach · Bensonhurst · Bay Ridge · Dyker Heights · Gravesend · Borough Park · Sheepshead Bay · Sunset Park · Coney Island · Marine Park · Midwood · Park Slope.
Get a free, same-week estimate from Brooklyn's drywall specialists.